Arise displays general setup instructions
 

su-1.jpg (5759 bytes) Remove frame from case and position on floor as shown.  Be sure the light mounts are on top and stand in front of the unit as it opens. Begin opening the frame by spreading it apart.
su-2.jpg (7270 bytes)
If you purchased spotlights, attach them now while the top of the frame is about waist level.
The lights are in the lid of the case. Press the spotlight base firmly onto the pre-applied light clip.  Squeeze to ensure a safe attachment. Always check the screws that hold the glass in place. These sometimes vibrate loose during shipping.		 su-3.jpg (2142 bytes)
su-4.jpg (2212 bytes)		 su-5.jpg (4714 bytes)
su-6.jpg (9589 bytes) Expand the unit fully by pulling firmly on the upper cross bars, then push the hubs together.  The magnetics will automatically connect to hold the frame in place.
su-7.jpg (4777 bytes)
Beginning at the bottom and working up, attach the magnetic metal mounting bars by slipping them onto the hubs where the small magnetics will hold them in place.  (Note: Mounting bars are applied to the front, but also to the two outside back corners for the endcaps.)		 su-9.jpg (3781 bytes)Start from one end and work to the other end. Otherwise the panels could "bubble" in some places. Hang the end panels, curl them around the corners and attach them to the mounting bars front and back. Hang the panels from the hanging pins at top, then attach them to the magnetic bars by aligning the magnetic strips. Magnetics to magnetics create a "self aligning" attachment.
su-8.jpg (6816 bytes)
Counter kit instructions
Arise I
If you purchased the standard Podium Conversion Kit, secure the two cases by strapping them together as shown at right.  Next, put the two- piece black metal top in position and attach the fabric side and back panels.  Neatly place the front panel last.

Arise II
If you purchased the single oval case Podium Conversion Kit, simply wrap the fabric panel around the shipping case as shown on right. Place the elliptical top piece within the recess on the shipping case top.

su-12.jpg (3789 bytes)


su-13.jpg (3090 bytes)
Packing instructions
!. Immediately unplug your lights so they can cool !
Use extreme caution: Bulbs and glass are extremely hot and stay hot for a long time after they are unplugged. Bulbs can be purchased and any hardware store, like Home Depot.

2. Remove all panels. Place the first one plastic down on the floor to keep from picking up lint and dirt. Place the others, fabric to fabric. Roll them up and place into the case.

3. Remove all magnetic mounting bars (twist off). Place them magnetic to magnetic and slide them into the box.

4. Disengage the magnetic locking bars to allow the frame to collapse.

5.Slowly and carefully, compress the frame. If you installed spotlights, remove them before the unit is fully compressed.

6. Rollup the fabric panels 2 at a time and place in case. Unroll so they expand to the outside of the case.

7. Be sure you have your address on the inside of the case. Use wire ties to secure the latches.

su-10.jpg (7224 bytes)Arise II case.
su-11.jpg (4659 bytes)Arise I case.

LiteStream Trade Show Displays
http://www.litestream.com